Surprisingly, the otherwise fairly minimalistic Sharp AL-1641CS is equipped with a built in duplexor.
This system can output 256 levels of grey at 600 x 600 dots per inch. Both scanning and copying are made possible by a moving optics/stationary top system with built in automatic exposure. Zooming can be down to degrees from 50% - 200% in 1% increments or in one of six preset sizes (50%, 64%, 78%, 100%, 129%, and 200%).
#How to reset drum on sharp printers full
It will take a full 16 seconds when making a copy from warm up mode and from complete shut off mode it will take 23 seconds before the first reproduction appears.īasic copy functions, such as reduction and enlargement, are present in the Sharp AL-1641CS. Continuous copies can be made in quantities of up to 99 at once and the device’s first copy and print out time slides just under the 10 second mark at 9.6 seconds. The unit’s copy speed exceeds that of its print speed, but is still fairly disappointing at 16 copies per minute. The ADF, as well as the unit’s paper storage trays and document glass, can handle paper up to 14” in length and 8.5” wide. The Sharp AL-1641CS’s extremely conservative specifications make it a fairly undesirable multifunctional device, though users will not be disappointed with its overall capabilities outside of its sluggish speed.Ī 30 page automatic document feeder sits atop the Sharp AL-1641CS and makes multiple page copy and scan projects manageable. Any indicator lights should now go off and the machine should become operational again. Close the side cover by pressing on the finger pad next to the OPEN latch, making sure that it closes entirely. With both toner and drum securely in place, close the front cover first. Reinstall the toner cartridge by sliding it into place next to the drum and pressing the release button until it is pushed all the way in.
#How to reset drum on sharp printers install
To install a new drum cartridge, the protective cover on the cartridge must first be removed, then the cartridge can be slid into the machine where the old one sat before. Old drum cartridges can and should be recycled properly. Once the toner cartridge has been safely removed, the drum unit can be pulled out of the machine by its handle. Keep it out of sunlight while the drum unit is being replaced. To remove the toner cartridge, press the button on the end of it to release it from the copy machine and pull it straight out of the unit. Open the side cover by pressing the OPEN button, then drop the front cover open by pressing in on its sides.īehind the front cover, the toner cartridge and drum unit will be seen. To remove the toner cartridge, begin by opening the multi purpose bypass tray if it is not already open. In order to replace the drum unit for this machine, the toner cartridge must be removed first. At this point, it is a good idea to order a new cartridge and replace the drum once the indicator light starts to blink. The unit will warn users when the cartridge is about 1,000 copies away from needing to be replaced by lighting a drum indicator light. This cartridge must be replaced regularly on an 18,000 copy cycle. Upon setup of the Sharp AL-1641CS copy machine, a drum cartridge will have to be installed.
0 kommentar(er)
